DJ Air Services offers a transparent pricing structure to our installations allowing you to see exactly what it is you will be paying for. This ensures you not only get exactly what you are after, it also ensures you don't pay for things you don't want.

Our installation packages can be tailored from the very basic back to back installation all the way to complex multi storey, internal wall installations. Ultimately the choice is yours

We can offer Gecko Protection Treatment and anti corrosion treatment for coastal areas. We disassemble the units and treat the coils and printed circuit boards with a specialist sealer that reduces the risk of corrosion and gecko damage which is not covered by manufacturers warranty. Check out the video for more information

BACK TO BACK INSTALLATION

The most cost effective installation is what we call a back to back per the diagram and includes the following:

• Indoor unit mounted on external facing wall

• Outdoor mounted behind at ground level

• Power should also be available on the external wall or close to it for 2.5 and 3.5kw units

• A new power circuit will be needed for 5kw or above units

• Isolator, cover duct, rubber feet and basic drain to ground are included in the basic back to back package

• In most cases we cannot install a unit over a window or doorway. We can certainly take a look and advise further.

SIDE EXIT INSTALLATION

Side exit installation simply means the indoor unit is located on an internal wall ideally in the corner of the room adjacent to the external wall and can be left hand exit or right hand exit configuration.

The same inclusions apply as per the back to back installation with the addition of a little extra time as a side exit installation takes a little more time to complete.

The indoor unit can also be optionally centered on the internal wall with cover duct fitted to hide the pipes and cables.

.

OVER CEILING INSTALLATION

Over ceiling installations involve the interconnecting services to run into the ceiling, through the ceiling and down to the indoor unit. This is the most complex and costly installation due to the amount and labour and materials required to install the system.

You can also opt for a condensate pump for internal wall mounting if desired.

Given the complexity of this installation they are quoted on a case by case basis.

.